英语翻译1.For capacitor charge it is necessary to take resistor with resistance 47 Ohm and 1Watt power.2.Measure voltage of stabilized power supply,what will be used to charge capacitor (desirable power supply voltage is 12-14V).3.Multiply measur

来源：学生作业帮助网 编辑：作业帮 时间：2024/04/29 00:02:30
英语翻译1.For capacitor charge it is necessary to take resistor with resistance 47 Ohm and 1Watt power.2.Measure voltage of stabilized power supply,what will be used to charge capacitor (desirable power supply voltage is 12-14V).3.Multiply measur

英语翻译1.For capacitor charge it is necessary to take resistor with resistance 47 Ohm and 1Watt power.2.Measure voltage of stabilized power supply,what will be used to charge capacitor (desirable power supply voltage is 12-14V).3.Multiply measur
英语翻译
1.For capacitor charge it is necessary to take resistor with resistance 47 Ohm and 1Watt power.
2.Measure voltage of stabilized power supply,what will be used to charge capacitor (desirable power supply voltage is 12-14V).
3.Multiply measured (received) power supply voltage by 0.67,for example – 14 V *0.67 = 9.38 V.Round up and have 9.4 V – it is voltage,to which capacitor has to be charged by resistor.
4.Multiply declared capacitance of capacitor by resistor resistance and as a result have charge equivalent time.For example:it is declared that capacitor volume (capacitance) is 1 Farad,then 47 Ohm * 1 Farad = 47 seconds.This capacitor has to be charged to 9,4 V in 47 seconds with the use of 47 Ohm resistor!
5.If it takes less time (for example,30 seconds) to charge capacitor to 9,4 V with the use of resistor,so its capacitance is lower than it was declared!Percentage of received capacitance can be calculated by proportion,where 47 seconds – 100%,30 seconds – X%.Totally 30*100/47 = 63.8% from declared capacitance.

英语翻译1.For capacitor charge it is necessary to take resistor with resistance 47 Ohm and 1Watt power.2.Measure voltage of stabilized power supply,what will be used to charge capacitor (desirable power supply voltage is 12-14V).3.Multiply measur
1.对于电容费用必须用电阻47欧姆电阻和1Watt力量.
2.测量电压稳定的电力供应,将用于收取电容(理想的电源电压是12-14V).
3.乘测量(收到)供电电压的,例如- 14 0.67 V =元至93.8 V凑0.67和9.4 V -它是电压,电容器必须由电阻.
4.电容器电容乘以宣布由电阻阻力,结果有同等的时间.例如:它是宣称电容器体积(电容)是1,那么47欧姆法拉法拉利= 47秒的垃圾.该电容器已被起诉至9秒,47个V使用47欧姆电阻!!!
5.如果需要更少的时间(例如,30秒)负责对9,4 V电容器采用电阻,所以它的容量是低于它被宣布!可接受的百分比计算容量比例,47秒- 100%,30秒- X %.30 100/47 = 63.8%完全从宣布电容.

英语翻译1.For capacitor charge it is necessary to take resistor with resistance 47 Ohm and 1Watt power.2.Measure voltage of stabilized power supply,what will be used to charge capacitor (desirable power supply voltage is 12-14V).3.Multiply measur 英语翻译1.For capacitor charge it is necessary to take resistor with resistance 47 Ohm and 1Watt power.2.Measure voltage of stabilized power supply,what will be used to charge capacitor (desirable power supply voltage is 12-14V).3.Multiply measur 英语翻译This effect is mainly used for thermal radiation detection at ambient temperature.Two metallic electrodes are deposited on faces perpendicular to the direction of the polarization,which yields a capacitor acting as thermal sensor.When the aluminum capacitor是什么意思 ceramic capacitor是什么意思 ballast capacitor是什么意思 ultra capacitor是什么意思 plate capacitor是什么意思 capacitor电容器的介绍 capacitor battery什么意思 ceramic capacitor是什么意思 coupling capacitor是什么意思 ceramic capacitor是什么意思 TRIMMER CAPACITOR是什么? list container total capacitor 电机驱动芯片SA57U的英文说明PDF的翻译VS: Supply voltage for the output transistors. These pins require decoupling (1μF capacitor with good high frequency characteristics is recommended) to the PGND pins. The decoupling capacitor should 英语翻译Across the line,resistor and / or inductor,capacitor,auto transformer,star / delta andvariable frequencystarters are supported. 请帮忙翻译supply capacitor